You may be able to unclog a sump pump without removing the entire unit, especially if the blockage is caused by loose debris around the intake, float switch or discharge line. The first step is to shut off electrical power to the pump before touching anything inside the pit.
Once the power is off, you can inspect the visible parts of the system and remove debris that can be reached safely.
Check the sump pit for loose debris
Leaves, gravel, mud and other material can collect around the pump and interfere with the intake. Remove any loose debris you can reach by hand or with a small scoop, being careful not to damage the pump or wiring.
If the pit contains a lot of sediment, cleaning the bottom of the pit may also help prevent the pump from clogging again.
Make sure the float switch can move freely
Sometimes what appears to be a clogged pump is actually a stuck float switch. If the float cannot rise and fall normally, the pump may fail to turn on or shut off at the right time.
Check for debris, cords or other objects that may be blocking the float. The switch should move freely without rubbing against the side of the pit or another component.
Check the pump intake
If the pump intake is visible, look for mud, gravel or other debris covering the openings. You may be able to clear the blockage without removing the pump by carefully brushing or wiping away the material.
Do not force tools into the intake or impeller area. If the clog is deeper inside the pump, the unit may need to be removed and serviced.
Inspect the discharge pipe
A sump pump can also stop moving water because the discharge line is clogged rather than the pump itself. Check any accessible sections of the pipe for visible blockages, kinks or frozen areas.
If the system has a check valve, make sure it is not stuck or obstructed. A blocked discharge line can make the pump run without actually lowering the water level in the pit.
Test the system after clearing the blockage
Once you have removed the visible debris, restore power and add enough water to the pit to raise the float. The pump should turn on, move the water out and shut off normally after the water level drops.
If the pump hums, runs without moving water or immediately clogs again, the problem may be inside the pump or farther down the discharge line.
When should you call for help?
If you cannot clear the blockage without taking the pump apart, or if the pump is making grinding or humming noises, it is better to have it inspected. A damaged impeller, failed motor or hidden discharge blockage may require more than basic cleaning.
Roberts Brothers Comfort can inspect the sump pump, clear blockages and determine whether the pump or discharge system needs repair. Call us at 937-909-3663 for help with your water heater or any indoor plumbing problem. We service homes across the area from both our Piqua and St. Paris offices.
