A bad sump pump usually gives you some warning before it fails completely. Common signs include unusual noises, frequent cycling, failure to turn on, water remaining in the pit or a pump that runs but does not actually move water.
You can check several basic things safely before assuming the pump itself is bad.
Make sure the pump has power
Start by confirming that the sump pump is plugged in and that the circuit breaker has not tripped. If the pump is connected to a GFCI outlet, check whether the outlet has tripped and needs to be reset.
If the breaker or outlet trips again after being reset, stop there. Repeated electrical trips can indicate a wiring, motor or pump problem that should be inspected.
Test the float switch
The float switch tells the pump when to turn on and off. If it gets stuck, tangled or blocked by debris, the pump may not run even if the motor itself is still good.
Make sure the float can move freely inside the pit. If the pump starts when the float is raised, the switch may have been obstructed rather than failed.
Listen to what the pump is doing
A healthy sump pump should start smoothly and move water out of the pit without excessive noise. Grinding, rattling, humming or buzzing can indicate a damaged impeller, worn motor or obstruction inside the pump.
A pump that hums but does not move water may be clogged, jammed or failing internally.
Check whether water is actually leaving the pit
If the pump runs but the water level does not drop, the problem may not be the pump itself. A clogged or frozen discharge line, stuck check valve or blocked outlet can prevent water from leaving the system.
Watch the water level during a test cycle. If the pump sounds normal but the pit stays full, the discharge system needs to be checked.
Look for frequent or continuous cycling
A pump that turns on and off constantly may have a float problem, check valve issue or improperly sized pit. Continuous running can also happen when groundwater is entering faster than the pump can remove it.
Frequent cycling puts extra wear on the motor and can shorten pump life, so repeated on-and-off operation should not be ignored.
Test the pump with water
If the pit is dry, you can carefully add enough water to raise the float and activate the pump. The pump should turn on, remove the water and shut off after the level drops.
If it does not start, struggles to move water or continues running after the pit is nearly empty, the pump or one of its controls may be failing.
When should you replace the sump pump?
Replacement may be the better option if the pump is old, unreliable, noisy, repeatedly clogs or no longer moves water effectively. A sump pump that has already failed during heavy rain is especially worth evaluating before the next storm.
Roberts Brothers Comfort can test your sump pump, diagnose the cause of the problem and recommend repair or replacement if needed. Call us at 937-909-3663 for help with your water heater or any indoor plumbing problem. We service homes across the area from both our Piqua and St. Paris offices.
